The spark plug forces electricity to arc across a gap. The electricity must be at very high voltage in order to travel across the gap and create a good spark. The spark plug needs to have an insulated passageway for this high voltage to travel down to the electrode, where it can jump the gap and be conducted into the engine block and grounded. The plug also has to withstand the extreme heat and pressure inside the cylinder. It must be designed so that deposits from fuel additives do not build up on the plug.
We can help with your car if you need a spark plug service
When you experience a sluggish engine, there’s a good chance that you could have a bad spark plug. Difficulty cranking, low momentum while running or sluggish performance in your engine can all mean spark plug failure. You can take your problem to a professional mechanic for a complete diagnosis, but there’s a way you can test the spark plugs yourself.
Step 1 for Spark Plug Service
Start by disconnecting each spark plug wire on your engine one at a time while the engine is running. If the engine drops speed or starts running rough when one is disconnected, you know that spark plug is good. If you disconnect a spark plug and no significant change happens in the engine, you have found a bad spark plug.
Step 2 for Spark Plug Service
Test the spark plug ignition by disconnecting the spark plug wire from the spark plug. Hold the end of the spark plug wire close to a metal surface. If the spark plug is good, you will see a spark or you’ll hear a crackling noise. This means that voltage is getting through the wire to the spark plug.
Step 3 for Spark Plug Service
See if there is a spark on each one of your spark plug wires when the engine is cranked. If compression is good, you will have spark on each one of your spark plug cylinders. No spark would mean that a spark plug wire is dead.
Step 4 for Spark Plug Service
Remember that each link connected to your spark plugs needs to be hooked up securely. Links include battery cable, ignition wires and coil wires, not just the spark plug wires.
Step 5 for Spark Plug Service
Wiggle the link connections from your spark plugs. Then test again. Sometimes it’s just a matter of a line connection being loose.
Step 6 for Spark Plug Service
Check to make sure that the end of each of the spark plugs is clean and free of any dirt, oil or grease deposits. Sometimes you can just clean them thoroughly and they’ll pass the test. But if they still don’t test well after cleaning, you’ll need to replace them.
If you are in Brisbane and you need a spark plug service then give us a call.